# Standard Deviation

The standard deviation (SD) tells how far the values of a data set are from the mean.

If the standard deviation is big, the values are, on average, far from the mean.

On the other hand, if the standard deviation is small, the values are, on average, close to the mean.

To see what we mean by “close or far to the mean”, consider the following data showing the grades of 5 students.

5 20 40 60 100

If you computed the mean and the SD for this data set, you will find that the mean is 45 and the SD is about 37.

The graph below shows the deviations from the mean. As you can see, the deviations shown with green lines are big.

This means that some grades, on average, are far from the mean, either below or above.

However, consider this time the following grades.

42 45 50 38 50

This time, the mean is again 45, but the SD is only 5.2

The deviations are small this time.

## Calculate Standard Deviation

Since the SD tries to find how far the values deviate from the mean, it makes sense to calculate the deviations from the mean for all the values.

Let us see how the SD was found for the grades below.

42 45 50 38 50

To obtain the deviation from the mean for a single value, just subtract the mean from that value.

The mean is 45.

42 – 45 = -3

45 – 45 = 0

50 – 45 = 5

38 – 45 = -7

50 – 45 = 5

It makes sense also to add -3, 0, 5, -7, and 5 together and then divide the result by 4 to get the “average” SD

However, -3 + 0 + 5 + -7 + 5 = 0 and 0 divided by 4 = 0.

Since there are 5 numbers, why do we divide by 4 instead of 5?

The reason is explained below in the last section.

We don’t get anything useful by adding -3, 0, 5, -7, and 5. To avoid getting 0, we can square the values before adding them.

9 + 0 + 25 + 49 + 25 = 108

Dividing 108 by 4 gives the variance or sample **variance.**

Variance = = 27

Since we had to square all the values to avoid getting zero, we need to take the square root of 27 to get the standard deviation.

SD = = 5.19 or 5.20

## Standard Deviation formula

To find the formula for standard deviation, we just need to generalize what we did above. Here are the steps.

**Step #1:**

Find the mean or

**Step #2:**

Subtract the mean from the values. Let x represent all the values and the mean, we get

**Step #3:**

Square each of the differences we found in step #2.

**Step #4:**

Add all the squares you found in step #3

**Step # 5:**

Let n be the number of value. Recall that in our example above, we divided by 4 intead of 5.

If n is the number of values, divide the sum above by n-1. We call this the variance.

Variance =

Now, why is the denominator n-1 instead of n?

**Step # 6:**

Recall that in step #3 we had to square the differences. Therefore, we need to take the square root of the variance to get the standard deviation.

Sample standard deviation = s =

For a population, we get:

Check out this nice standard deviation calculator

## 2 Comments

## Leave your reply.